ABB REB650 Manual page 39

1MRK 511 419-UUS A
1.2b Serial Capabilities
connections
● Not checked
○ No gap permitted
○ Fixed at bit times
○ Fixed at ms
○ Configurable, range ___ to ___ bit times
○ Configurable, range ____ to ____ ms
○ Configurable, Selectable from ___,___,___bit times
○ Configurable, Selectable from _ _ _ ms
○ Configurable, other, describe:
○ Variable, explain:
1.2.8 Inter-character gaps in transmission: When serial interfaces with asynchronous character framing are used, this parameter indicates
whether extra delay is ever introduced between characters in the message, and if so, the maximum width of the gap. Where no asynchronous
serial interface is fitted, this parameter is not applicable. In this case, none of the options shall be selected
● None (always transmits with no inter-character gap)
○ Maximum _____ bit times
○ Maximum _____ ms
Table 5: IP networking
1.3 IP networking Capabilities
1.3.1 Port Name: name
used to reference the
communications port
defined in this section
1.3.2 Type of end point:
○ TCP Initiating (Master Only)
● TCP Listening (Outstation Only)
○ TCP Dual (required for Masters)
● UDP Datagram (required)
1.3.3 IP address of this
device:
1.3.4 Subnet mask:
1.3.5 Gateway IP
address:
1.3.6 Accepts TCP connections or UDP datagrams from:
Table continues on next page
650 series 2.2 ANSI
Point list manual
DNP3 protocol implementation
Current
value
Not
checked
None
Current value If configurable, list
methods
Both back-ports
TCP listening
*.*.*.* PST or LHMI
*.*.*.* PST or LHMI
*.*.*.* PST or LHMI
Section 3
If configurable,
list methods
33