Connecting Injection Unit Rex060, Coupling Capacitor Unit Rex061 And Shunt Resistor Unit Rex062 - ABB RELION 670 Series Installation Manual

1MRK 514 026-UEN B
6.2.2
670 series 2.2 IEC
Installation manual
1MRK002556-BA-2-PG V2 EN-US
Figure 38: Shunt resistor module
Connecting injection unit REX060, coupling capacitor unit
REX061 and shunt resistor unit REX062
The injection unit REX060 should be installed close to the IED in the same
cubicle, or at minimum within 10 m distance of the IED.
The coupling capacitor unit REX061 should be mounted close to the generator in
order to limit the exposure of the field circuit. Alternatively it can be located in the
excitation cubicle. REX061 should be connected as a permanently connected
equipment. The connection cables should be at least 1.5 mm
rotor injection voltage 250 V and rated field injection voltage 800 V
The shunt resistor unit REX062, if used in the application, should preferably also
be installed in the same cubicle as REX060.
For information on type, cross section and maximum length of the
cables refer to section Connection diagrams in the REG 670
Technical Manual.
Connecting to protective earth
Connect the protective earthing screw on the rear of each unit to the closest
possible earthing point in the cubicle. Electrical codes and standards require that
protective earth cables are green/yellow conductors with a cross section area of at
2
least 2.5 mm (AWG 14).
The cubicle must be properly connected to the station earthing system. Use a
conductor with a core cross section area of at least 4 mm
Connecting the power supply module
The wiring from the cubicle terminal block to the REX060 unit (see figure
PSM connection diagram) must be made in accordance with the established
Section 6
Connecting
GUID-0B6A1CDE-9CDE-413C-9E85-9314175D901E v4
2
(16 AWG) at rated
.
DC
2
(AWG 12).
32 for
63