ABB ACS800 Hardware Manual page 74

74
Connecting the power cables of units with EMC filter +E202. Frame size R8 with top entry and exit.
Step Instruction
3 Cut an adequate hole to the rubber grommet in the lead-through plate and lead the motor cable through the
grommet and the conductive sleeve into the cabinet.
4 Peel off 3 to 5 cm of the outer insulation of the cable above the lead-through plate for the 360° high-frequency
earthing.
5 Fasten the conductive sleeve to the cable shield with cable ties.
6 Tie up the unused conductive sleeves with cable ties.
7 Connect the twisted shield of the motor cable to the PE busbar of the cabinet.
8 Connect the phase conductors of the motor cable to the U2, V2 and W2 terminals.
9 If optional brake chopper is included, lead the brake resistor cable into the cubicle as described above. Connect the
brake resistor conductors to the R+ and R- terminals and the twisted shield to the PE busbar.
10 Fasten the EMC screens. See the photo on the previous page.
Lead-through plate
Roof plate
Strip this part
4
of the cable
7
PE busbar
Cable shield
Installation
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
3
6
5
EMC sleeve
Photo
6
OUTPUT
INPUT
W1
Connecting the motor cable
PE
7
8 8 8 9 9
U2 V2
W2 R+ R-
V1
U1