Table of Contents
Advertisement
OPERATION
3.18 VIEWING SOFTWARE INFORMATION
The user can see information about the software in the WAG.
The information can be saved to a file. For more information on how to save displays to a file, see
the documentation for the terminal emulation software or for the Telnet application.
To View the Software Information:
Type project and press Enter. The software information appears, similar to the following:
Information about Wayside Access Gateway project:
Current Date / Time:
RTOS RAM start: ...........0x200
RTOS RAM end: .............0x69200 (430080 bytes)
Zerovars start: ...........0x69200
Zerovars end: .............0x6C030 (11824 bytes)
Fixed Buff start: .........0x6C030
Fixed Buff end: ...........0x7D330 (70400 bytes)
Fixed Buff Remaining: .....0x104 (260 bytes)
System Log start: .........0x7D330
System Log end: ...........0x7FB30 (10240 bytes, 102 lines)
Unallocated Heap start: ...0x7FB50
Unallocated Heap end: .....0x80000 (1200 bytes)
Executable start: .........0x230004
Executable end: ...........0x24B40A (111622 bytes)
System run time: .........0 days, 18 H 13 M 55 S
The Current Date / Time will be displayed if the date and time has been set;
otherwise the time elapsed since the WAG acquired power will be displayed
.
The Project run time will display the amount of time elapsed since the WAG
acquired power however, if the date and time are set, the Project run time will
continue to display elapsed time.
3.19 REVIEWING THE LOGS
The log shows the user system information and any problems the WAG might have encountered.
Only the last 102 events are stored in the log.
The user can save this information to a file. For more information, see the documentation for the
terminal emulation software or for the Telnet application.
Document No.: COM-00-05-16
Version: C.1
01/01/00 00:08:10.067
NOTE
3-16
June 2006, Revised June 2014
Advertisement
Table of Contents
Troubleshooting
