Table of Contents
Advertisement
2. To keep the current TCP port assignments, press ENTER. If not, enter the assignment value for
slots 1 through 4 and then press ENTER.
When finished, the user will be returned to the First Configuration Menu. The TCP port
numbers are shown.
3. Prior to exiting the First Configuration Menu, select "Save changes then restart" to save
changes and restart the WAG.
2.6.11
DHCP Server
The Dynamic Host Configuration Protocol (DHCP) server (or Site ID) can be enabled or disabled
depending on whether the WAG is required to provide configuration information for up to five
A53325 Safetran Ethernet Radios. When DHCP is enabled, the WAG will support the A53325
Safetran Ethernet Radio operation running Linear Network Software.
To Change the DHCP Server:
1.
On the First Configuration Menu, select "DHCP server" to be changed. The DHCP Server
screen appears.
2.
To keep the current configuration, press ENTER. If not, make a selection and press ENTER.
Document No.: COM-00-05-16
Version: C.1
Figure 2-22. TCP Configuration Screen
Figure 2-23. DHCP Server Screen
2-21
INSTALLATION AND CONFIGURATION
June 2006, Revised June 2014
Advertisement
Table of Contents
Troubleshooting
