Connecting Using Telnet; Figure 2-9. First Configuration Menu - Siemens A53457 Installation & Maintenance

2.5

CONNECTING USING TELNET

To connect the WAG using the Telnet software, perform the following steps:
To log in using Telnet software:
A Telnet connection may not be possible if the computer IP address and subnet
mask do not allow access to the WAG configured IP address.
1. Open Telnet software.
2. If this is the first time connecting to the WAG, go to 10.232.53.40, port 23. If this is not
the first time, connect to the previously specified IP address for the unit.
The Telnet session is dropped after configuration changes have been saved. If
the WAG has been reconfigured, the IP address may not be 10.232.53.40.
When connected to the WAG, type con and press ENTER. The First Configuration Menu appears.
Document No.: COM-00-05-16
Version: C.1

Figure 2-9. First Configuration Menu

2-9
INSTALLATION AND CONFIGURATION
NOTE
NOTE
June 2006, Revised June 2014