Siemens A53457 Installation & Maintenance page 108

OPERATION
Table 3-2 continued
Classification Log Entry
Fatal
XPORT is not
responding.
Fatal
WAG's IP address
<xx.xx.xx.xx> is
already in use!
Fatal
Error: Fixed memory
pool <x> exhausted
Fatal
FLASH: Couldn't erase
boot sectors!
Fatal
FLASH: Couldn't erase
application sectors!
Fatal
FLASH: Couldn't write
boot sectors!
Fatal
FLASH: Couldn't write
application sectors!
Warning
ERROR: ECH RX Not
first
Warning
ERROR: Ser RX Not
first
Warning
ERROR: Ser TX Not
first
Warning
ERROR: XPT RX Not
first
Warning
ERROR: XPT TX Not
first
Document No.: COM-00-05-16
Version: C.1
Description
Means there is a hardware error or that the
XPort is improperly configured.
Another device on the Ethernet LAN has the
same IP address as the configured IP address
of the WAG.
Indicates a programming error. Used by
Siemens Rail Automation personnel for
troubleshooting.
There is a problem with erasing FLASH ROM.
There is a problem with erasing FLASH ROM.
There is a problem with writing FLASH ROM.
There is a problem with writing FLASH ROM.
Used by Siemens Rail Automation personnel
for troubleshooting.
Means that a serial interface error occurred.
Used by Siemens Rail Automation personnel
for troubleshooting.
Means that an outbound serial message was
attempted to be transmitted out a transmit
buffer descriptor table entry that was not the
next expected buffer. Used by Siemens Rail
Automation personnel for troubleshooting.
Means that an inbound Ethernet message was
received by a receive buffer descriptor table
entry that was not the next expected buffer.
The WAG corrects itself and continues without
a problem.
Means that an outbound Ethernet message
attempted to transmit out a transmit buffer
descriptor table entry that was not the next
expected buffer. The WAG corrects itself and
continues without a problem.
3-20
June 2006, Revised June 2014