Multiplexer Commands - HP E1351A User Manual

Multiplexer Commands

ARM:COUNt <
INITiate[:IMMediate]
INITiate:CONTinuous <
< mode > = 1 | 0 | ON | OFF
[ROUTe:]CLOSe <
[ROUTe:]CLOSe? <
[ROUTe:]OPEN <
[ROUTe:]SCAN <
[ROUTe:]SCAN:MODE FRES
[ROUTe:]SCAN:PORT ABUS
TRIGger[:IMMediate]
TRIGger:SOURce <
< source > = EXT | BUS | DBUS | IMM
NOTE: The commands with brackets ([ ]) are implied and are not shown in this chapter.
Chapter 3
The following commands are covered in Chapter 3. For a complete list and
description of commands see Chapter 5, "Command Reference".
Table 3-1. Matrix Commands Used in Chapter 3
Command
number >
mode
>
channel_list
>
channel_list
>
channel_list >
channel_list >
source
>
Using the HP E1351A/53A FET Multiplexer Modules
Selects number of scanning cycles for a switchbox only. Does not
apply to downloaded scan lists.
Channel advance for TRIGger:SOURce BUS | HOLD.
Enables/disables continuous scanning cycles.
Closes specified channels.
Queries mainframe for channel closure.
Opens specified channels.
Closes all channels in channel list one at a time. Previous channel
opens before next channel closes.
Closes paired channel relays (for example, channels 01 and 09)
during 4-wire ohms measurements.
Automatically closes the tree isolation switches.
Channel advance for TRIGger:SOURce BUS | HOLD.
Selects the trigger source as EXTernal, HP-IB BUS, Digital BUS,
or IMMediate.
Description
31