Ieee 488.2 Common Commands - HP E1351A User Manual

IEEE 488.2 Common Commands

Command
*IDN? Identification
*RST Reset
*TST? Self-Test
*OPC Operation Complete
*OPC? Operation Complete Query
*WAI Wait to Complete
*CLS Clear status
*ESE Event status enable
*ESE? Event status enable query
*ESR? Event status register query
*SRE Service request enable
*SRE? Service request enable query
*STB? Read status byte query
*TRG Trigger
*RCL Recall instrument state
*SAV Store instrument state
Note: These commands apply to many instruments and are not documented in detail here. See the
Series B E1300/E1301 Mainframe User's Manual
76 HP E1351A/53A 16-Channel FET Multiplexer Command Reference
The following table lists the IEEE 488.2 Common (*) Commands that the
16-Channel FET Multiplexer Modules accept. The operation of some of
these commands is described in Chapter 4 of this manual. For more
information on Common Commands, refer to the HP 75000 Series B
Mainframe User's Manual (HP Model Number E1300/E1301) or the
ANSI/IEEE Standard 488.2-1987.
Title
Returns identification string of the switchbox.
Opens all channels, and invalidates current
scanning. Sets ARM:COUN 1, TRIG:SOUR IMM, and INIT:CONT OFF.
Power-on interrupt returns +110
Incorrect MFR ID or model code returns +103
Test pass returns 0.
See note below.
See note below.
See note below.
Clears all status registers (see STATus:OPERation[:EVENt]?).
See note below.
See note below.
See note below.
Enables status register bits (see Chapter 4 for operation).
See note below.
See note below.
Triggers the switchbox to advance the scan when scan is enabled
and trigger source is TRIGger:SOURce BUS | HOLD.
See note below.
See note below.
or the ANSI/IEEE Standard 488.2-1987 for more information.
Description
channel list
HP 75000
for
Chapter 5