ARM
Subsystem Syntax
:COUNt
Parameters
Comments
Example
:COUNt?
Parameters
Comments
Example
Chapter 5
The
subsystem selects the number of scanning cycles (1 - 32767) for
ARM
each
command. This command does not apply to downloaded scan
INIT
lists. For downloaded scan lists, use
ARM
:COUNt <
:COUNt? [MIN | MAX]
ARM:COUNt <
multiple of times (1 to 32767) with one
INITiate:CONTinuous OFF | 0
sets 32,767 scanning cycles.
Parameter Name
number
•
Number of Scans: Use only numeric values between 1 to 32767 for
the number of scanning cycles (default is 1).
•
Related Commands:
•
*RST Condition:
Setting Ten Scanning Cycles
ARM:COUN 10
SCAN (@100:115)
INIT
ARM:COUNt? [MIN | MAX]
set by
ARM:COUNt
returns 32767.
Parameter Name
MIN | MAX
•
Related Commands:
Query Number of Scanning Cycles
ARM:COUN 10
ARM COUN?
HP E1351A/53A 16-Channel FET Multiplexer Command Reference
INIT:CONT ON
number
> MIN | MAX
number
> MIN | MAX
allows scanning cycles to occur a
is set.
MIN
Parameter Type
Numeric
ABORt
,
INITiate[:IMMediate]
ARM:COUNt 1
returns the current number of scanning cycles
.
ARM:COUN? MIN
Parameter Type
Numeric
INITiate[:IMMediate]
for multiple scans.
INITiate
command and when
sets 1 scanning cycle and
Range of Values
1 - 32767 | MIN | MAX
Set 10 scanning cycles.
Sets channel list.
Starts scanning cycle.
returns 1 and
ARM:COUN? MAX
Range of Values
MIN = 1, MAX = 32767
Sets 10 scanning cycles.
Query number of scanning cycles;
returned value is 10.
MAX
57