Output; [:State] - HP E1351A User Manual

OUTPut

Subsystem Syntax

[:STATe]

Parameters
Comments
Example
[:STATe]?
Example
62 HP E1351A/53A 16-Channel FET Multiplexer Command Reference
The subsystem enables or disables the "Trig Out" port of the HP
OUTPut
E1300/E1301 Mainframe.
OUTPut
[:STATe] < state >
[:STATe]?
state
OUTPut[:STATe] <
panel of the HP E1300/E1301 Mainframe.
the port and OUTPut[:STATe] OFF | 0
Parameter Name Parameter Type
state
•
Downloaded Scans: The
downloaded scan lists. The scan list is downloaded automatically if
you use
TRIG:SOUR DBUS
only). works with all other scanning methods.
OUTPut
•
Enabling "Trig Out" Port: When enabled, the "Trig Out" port is
pulsed each time a channel is closed during scanning. When
disabled, the "Trig Out" port is not pulsed.
•
Output Pulse: The pulse is a +5 V negative-going pulse.
•
"Trig Out" Port Reserved by Switchboxes: The "Trig Out"
resource is a system resource, and can only be reserved by one
instrument at a time.
•
Related Commands:
•
*RST Condition:
Enabling "Trig Out" Port
OUTP ON
queries the present state of the "Trig Out" port. The
OUTPut[:STATe]?
command returns 1 if the port is enabled, or 0 if disabled.
Query "Trig Out" Port State
OUTP ON
OUTP:STAT?
enables/disables the "Trig Out" port on the rear
>
OUTPut[:STATe] ON | 1
disables the port.
Boolean
OUTPut subsystem does not work with
or
TRIG:SOUR IMM
,
[ROUTe:]SCAN TRIGger:SOURce
OUTPut[:STATe] OFF
Enables "Trig Out" port for pulse
output.
Enables "Trig Out" port for pulse
output.
Query port enable state.
enables
Range of Values
0 | 1 | ON | OFF
(FET multiplexers
(port disabled)
Chapter 5