Table of Contents
Advertisement
Parameters
accounting: Sets the status of the secondary RADIUS accounting server.
authentication: Sets the status of the secondary RADIUS authentication/authorization server.
active: Specifies the active state, the normal operation state.
block: Specifies the blocked state, the out-of-service state.
Description
Use the state secondary command to set the status of a secondary RADIUS server.
By default, every secondary RADIUS server specified in a RADIUS scheme is in active state.
If no IP address is specified, this command changes the status of all configured secondary servers for
authentication/authorization or accounting.
If the device finds that a secondary server in active state is unreachable, the device changes the status of
the secondary server to blocked, starts a quiet timer for the server, and continues to try to communicate
with the next secondary server in active state (a secondary RADIUS server configured earlier has a
higher priority). When the quiet timer of a server times out, the status of the server changes to active
automatically. If you set the status of the server to blocked before the quiet timer times out, the status of
the server cannot change back to active automatically unless you set the status to active manually. If all
configured secondary servers are unreachable, the device considers the authentication or accounting
attempt a failure.
Related commands: display radius scheme and state primary.
Examples
# Set the status of all the secondary servers in RADIUS scheme radius1 to blocked.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] state secondary authentication block
stop-accounting-buffer enable (RADIUS scheme view)
Syntax
stop-accounting-buffer enable
undo stop-accounting-buffer enable
View
RADIUS scheme view
Default level
2: System level
Parameters
None
Description
Use the stop-accounting-buffer enable command to enable the device to buffer stop-accounting requests
to which no responses are received.
Use the undo stop-accounting-buffer enable command to disable the buffering function.
By default, the device buffers stop-accounting requests to which no responses are received.
115
Advertisement
Table of Contents
