Table of Contents
Advertisement
Description
Use the secondary authentication command to specify the secondary HWTACACS authentication
server.
Use the undo secondary authentication command to remove the configuration.
By default, no secondary HWTACACS authentication server is specified.
The IP addresses of the primary and secondary authentication servers must be different. Otherwise, the
configuration fails.
If you configure the command repeatedly, only the last configuration takes effect.
You can remove an authentication server only when it is not used by any active TCP connection to send
authentication packets is using it. Removing an authentication server affects only authentication
processes that occur after the remove operation.
Related commands: display hwtacacs.
Examples
# Specify the IP address and port number of the secondary authentication server for HWTACACS
scheme hwt1 as 10.163.155.13 with TCP port number 49.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] secondary authentication 10.163.155.13 49
secondary authorization
Syntax
secondary authorization ip-address [ port-number ]
undo secondary authorization
View
HWTACACS scheme view
Default level
2: System level
Parameters
ip-address: IP address of the secondary HWTACACS authorization server in dotted decimal notation.
The default is 0.0.0.0.
port-number: Service port number of the secondary HWTACACS authorization server. It ranges from 1
to 65535 and defaults to 49.
Description
Use the secondary authorization command to specify the secondary HWTACACS authorization server.
Use the undo secondary authorization command to remove the configuration.
By default, no secondary HWTACACS authorization server is specified.
The IP addresses of the primary and secondary authorization servers cannot be the same. Otherwise, the
configuration fails.
If you configure the command repeatedly, only the last configuration takes effect.
132
Advertisement
Table of Contents
