Table of Contents
Advertisement
Rear Panel
8 SCSI connector (option)
This connector is attached to the ESBK-7051 SCSI
Option board. It allows you to connect an MO drive.
The MO drive is used to store edit data with index
pictures, and to exchange edit data with other
equipment.
3 System control section
CONTROL PANEL
1 PLAYER 1 connector (D-sub 9-pin)
Outputs control signals for the player 1 VCR. Connect
to the REMOTE connector of the player 1 VCR.
2 PLAYER 2 connector (D-sub 9-pin)
Outputs control signals for the player 2 VCR. Connect
to the REMOTE connector of the player 2 VCR.
3 AUX (auxiliary) connector (D-sub 9-pin)
Outputs control signals for an auxiliary VCR. Connect
to the REMOTE connector of the VCR connected to
the AUX connector..
4 RECORDER connector (D-sub 9-pin)
Outputs control signals for the recorder VCR. Connect
to the REMOTE connector of the recorder VCR.
100
Chapter 4 Location and Function of Parts
1 PLAYER 1 connector
2 PLAYER 2 connector
3 AUX connector
GPI(PARALLEL)
GPI(232)
RECORDER
AUX
4 RECORDER connector
5 GPI (232) connector
6 GPI (PARALLEL) connector
7 CONTROL PANEL connector
5 GPI (232) connector (D-sub 9-pin)
Outputs commands to control external equipment. This
connector complies with the RS-232C standard.
See page 94 for the pin assignments.
6 GPI (PARALLEL) connector (D-sub 9-pin)
Outputs timing pulses to control external equipment.
Connect to the GPI input connector of the external
equipment. There are 4 ports. The signals output by the
4 ports are as follows.
Ports 1, 2: TTL output and relay output
Ports 3, 4: TTL output
See page 94 for the pin assignments.
7 CONTROL PANEL connector (D-sub 15-pin)
Connect the optional ESBK-7011 Control Panel.
PLAYER 2
PLAYER 1
Advertisement
Table of Contents
