Table of Contents
Advertisement
SYNC connector (BNC type): Output sync signals
generated by the built-in sync signal generator.
Connect to the reference video input connector of
a video monitor only when you output signals
from this unit to the video monitor in RGB mode.
7 MON IN connector
Input composite video signals for the buit-in monitor
switcher. Connect to the composite video output
connector of the recorder VCR.
7 DME switcher section (option)
DFS connector (D-sub 9-PIN)
Outputs signals to control an external DME switcher.
Connect to the EDITOR connector of the DFS-300/
300P/500/500P.
Note
When connecting the ES-7 and the DFS-300/300P/
500/500P, set the editor selection switch on the system
control board of the DFS-300/300P/500/500P as
follows.
DFS-300/300P: PVE-500
DFS-500/500P: BVE-900
8 GEN LOCK IN connector
Input an external reference video signal. Use a T
connector for a through connection not terminated at
this unit.
9 75Ω ON/OFF switch
Specify whether or not to terminate with a 75Ω
terminator the external reference video signal input to
the GEN LOCK IN connector 8.
ON: Terminate.
OFF: Do not terminate.
DFS
DFS connector
About the ROM version number of the DFS-
500/500P
To connect a DFS-500/500P switcher to this unit, the
version of the ROM on the SY board of the DFS-500/
500P must be 1.04 or higher. The following DFS-500/
500P switchers meet this requirement.
• DFS-500 with serial number 12000 or higher
• DFS-500P with serial number 24000 or higher
• DFS-500 with BKDF-504/504P installed
To connect a DFS-500/500P other than those listed
above, a ROM update is required. For details, contact
your Sony dealer or a Sony service representative.
Chapter 4 Location and Function of Parts
105
Advertisement
Table of Contents
