Installing Daughter Boards - Sony EditStation ES-7 Operating Instructions Manual

Installing Daughter Boards

Installing the ESBK-7022 3D Effect Board for Basic DME Switcher
Proceed as follows to install the ESBK-7022 board on
the MY-74 board of the ESBK-7021 Basic DME
Switcher Board. (The MY-74 board is the board
without a connector panel.)
1
Press the ESBK-7022 board
down onto the MY-74 board
until the two connectors on the
ESBK-7022 are firmly seated
in the two connectors on the
MY-74 board.
2
Using the supplied screws,
fasten the ESBK-7022 board to
the MY-74 board.
3
Remove the connector panel of
the FM-43 board of the ESBK-
7021.
Press down firmly until there are no gaps
between the upper and lower connectors when
viewed from direction 1.
1
ESBK-7022
MY-74 board of
ESBK-7021
Yes
No gaps
No
Gaps
FM-43 board of ESBK-7021
Chapter 3 Connections and Settings
81