Table of Contents

Advertisement

Front Panel

1 POWER switch
Turns the power on and off. Be sure to carry out the
Windows NT shutdown procedure before turning the
power off.
For the Windows NT shutdown procedure, see "Shutting
Down the System" (page 26).
2 CD-ROM access indicator
Normally lights in green, and lights in orange to
indicate that the unit is reading from a CD-ROM disc.
3 CD-ROM tray cover
This is the cover of the tray where CD-ROM discs are
placed.
4 CD-ROM EJECT button
Press this button to open the CD-ROM tray to insert or
remove a disc. To close the tray, push it in.
5 Floppy disk access indicator
Lights to indicate that the unit is writing to or reading
from a floppy disk.
1 POWER switch
2 CD-ROM access indicator
3 CD-ROM tray cover
4 CD-ROM EJECT button
5 Floppy disk access indicator
6 Floppy disk insertion slot
7 Floppy disk EJECT button
8 HEADPHONES knob
9 Headphones connector
These parts cannot currently be used.
6 Floppy disk insertion slot
Insert 3.5-inch floppy disks here.
7 Floppy disk EJECT button
Press to eject a floppy disk.
Note
Do not press this button while the floppy disk access
indicator is lit.
8 HEADPHONES knob
Controls the volume of the headphones connected to
the headphones connector 9.
9 Headphones connector (stereo phone jack)
Connect headphones. This connector outputs the same
signals as the MONITOR OUTPUT 1/3, 2/4
connectors on the rear panel.
Chapter 4 Location and Function of Parts
97

Advertisement

Table of Contents
loading

Table of Contents