Table of Contents
Advertisement
Installing Optional Boards
4
Insert the two ROMs (IC5 and
IC6) supplied with the ESBK-
7022 into the sockets of the
FM-43 board of the ESBK-
7021 board. When inserting,
align the notches on the ROMs
with the notches in the sockets.
After inserting the ROMs,
attach the connector panel of
the FM-43 board in its original
position.
Installing the ESBK-7024 3D Effect Board for Advanced DME Switcher
Proceed as follows to install the ESBK-7024 board on
the MY-75 board of the ESBK-7023 Advanced DME
Switcher Board. (The MY-75 board is the board
without a connector panel.)
1
Press the ESBK-7024 board
down onto the MY-75 board
until the three connectors on
the ESBK-7024 are firmly
seated in the three connectors
on the MY-75 board.
2
Using the supplied screws,
fasten the ESBK-7024 board to
the MY-75 board.
82
Chapter 3 Connections and Settings
Notches
1
Press down firmly until there are no gaps between the upper
and lower connectors when viewed from direction 1.
FM-43 board of ESBK-7021
IC5
IC6
ESBK-7024
MY-75 board of
ESBK-7023
Yes
No gaps
No
Gaps
Advertisement
Table of Contents
