Installing Expansion Boards On The Motherboard - Sony EditStation ES-7 Operating Instructions Manual

Installing Expansion Boards on the Motherboard

Use the procedure described below to install the
following expansion boards on the motherboard.
• ESBK-7041 Disk Recorder Board
• ESBK-7031 QSDI Interface Board
• ESBK-7021 Basic DME Switcher Board
• ESBK-7023 Advanced DME Switcher Board
• ESBK-7025 External Switcher Interface Board
Note
The following optional boards are daughter boards that
install on another optional board (parent board).
Before installing the parent board on the motherboard,
install the daughter board on the parent board.
1
Remove the two screws and
remove the blank panel.
Caution
Before removing the blank
panel, loosen the screws of the
blank panels or connector
panels in the slots above and
below it, so that these panels
can be moved slightly. If this is
not done, force is required to
remove the blank panel and
injury can result.
2
Insert the optional board into
the specified slot.
If you want to install a daughter board on a parent
board that has already been installed on the
motherboard, remove the parent board from the
motherboard and reinstall it after installing the
daughter board.
• ESBK-7022 3D Effect Board for Basic DME
Switcher (see page 81)
• ESBK-7024 3D Effect Board for Advanced DME
Switcher (see page 82)
• ESBK-7032 SDI Interface Board (see page 83)
• DAC Board for ESBK-7071/7025 (see page 84)
Chapter 3 Connections and Settings
77