Configuration Guidelines; Scheduling A Device Reboot - HP 10500 Series Configuration Manual

Immediately reboot the device at the CLI.
•
• Schedule a reboot at the CLI, so the device automatically reboots at the specified time or after the
specified period of time.
Power off and then power on the device. This method might cause data loss, and is the
•
least-preferred method.
Using the CLI, you can reboot the device from a remote host.

Configuration guidelines

When you schedule a reboot, follow these guidelines:
In standalone mode, the automatic reboot configuration is canceled if an active/standby
•
switchover occurs.
• In IRF mode, the automatic reboot configuration is effective on all member devices. It will be
canceled if a switchover between the global active MPU and a global standby MPU occurs.
For data security, the device does not reboot while it is performing file operations.
•
Rebooting devices immediately at the CLI
Execute one of the following commands as appropriate in user view:
Task
Reboot a card, a subcard, or
the entire device. (In standalone
mode.)
Reboot an IRF member device, a
subcard, or all IRF member
devices. (In IRF mode.)

Scheduling a device reboot

The device supports only one device reboot schedule. If you configure the scheduler reboot at or
scheduler reboot delay command multiple times or configure both commands, the most recent
configuration takes effect.
To schedule a reboot, execute either of the following commands in user view:
Task
Specify the reboot date
and time.
Specify the reboot delay
time.
Command
reboot [ slot slot-number [ subslot
subslot-number ] ] [ force ]
reboot [ chassis chassis-number [ slot
slot-number [ subslot
subslot-number ] ] ] [ force ]
Command
scheduler reboot at time [ date ]
scheduler reboot delay time
221
Remarks
The subslot subslot-number option is
not supported.
The subslot subslot-number option is
not supported.
Remarks
By default, no reboot date or time is specified.
By default, no reboot delay time is specified.