Configuration Restrictions And Guidelines; Configuration Procedure - HP 10500 Series Configuration Manual

Operating mode
H191A, JH199A)
LSUM2GT48SE0(JH
192A, JH200A)
SF interface modules
SG interface modules
NOTE:
1K represents 1024 entries.

Configuration restrictions and guidelines

When you specify an operating mode for a service module, follow these restrictions and guidelines:
The LSU1CGC2SE0(JG916A) interface module does not support setting the operating mode.
•
An EA or EB interface module might reboot once or twice for self-optimization the first time you
•
change its operating mode or upgrade the software version of the switch after changing the card
operating mode. The process takes approximately 6 to 10 minutes.
• If the device has multiple EA or EB interface modules, specify the same operating mode for them.
To make an operating mode change take effect, save the configuration and reboot the service
•
module.

Configuration procedure

To specify an operating mode for a service module:
Step
1. Enter system view.
2. Specify an
operating mode for
a service module.
normal bridging
supported
MAC:
128K
Not
Routing:
supported
IPv4—16K
IPv6—8K
Not MAC:
supported 288K
Command
system-view
•
In standalone mode:
switch-mode { acl-ipv4 | acl-l2
| bridging | high-speed |
ipv6 | low-speed |
mix-bridging-routing | normal
| port-extender | routing |
standard-ipv6 } slot
slot-number
•
In IRF mode:
switch-mode { acl-ipv4 | acl-l2
| bridging | high-speed |
ipv6 | low-speed |
233
mix-bridgi
routing
ng-routing
supported
Routing:
IPv4—32K
IPv6—12K
Not Not
supported supported
MAC:
Routing:
160K
IPv4—128
Routing:
K
IPv4—16K
IPv6—20K
IPv6—6K
Remarks
N/A
The default mode is as follows:
•
mix-bridging-routing for the following
interface modules:
EA interface modules.
EB interface modules.
EC interface modules.
SG interface modules.
LSUM2GP44TSSE0(JH191A,
JH199A).
LSUM2GT48SE0(JH192A,
standard-i
ipv6
pv6
supported supported
MAC:
128K
Not
Routing:
supported
IPv4—16K
IPv6—8K
Not Not
supported supported