Restoring The Factory-Default Configuration - HP 10500 Series Configuration Manual

3. Enter the number of the destination storage medium. For example, enter 1 to copy the file to the
flash memory.
Enter your choice(0-1):1
The destination file can't be the same as the source file.

Restoring the factory-default configuration

CAUTION:
Performing this task can cause all next-startup configuration files in the current storage medium to be
permanently deleted.
IMPORTANT:
Perform this task only if the switch has one MPU. If the switch has two MPUs, you cannot restore the
factory-default configuration.
To restore the factory-default configuration from the EXTENDED-BOOTWARE menu, make sure password
recovery capability is disabled. If the capability is enabled, you cannot perform the task.
To enable the system to start up with the factory-default configuration instead of a next-startup
configuration file:
1. Enter 5 in the EXTENDED-BOOTWARE menu.
==========================<EXTENDED-BOOTWARE MENU>==========================
|<1> Boot System
|<2> Enter Serial SubMenu
|<3> Enter Ethernet SubMenu
|<4> File Control
|<5> Restore to Factory Default Configuration
|<6> BootWare Operation Menu
|<7> Skip Authentication for Console Login
|<8> Storage Device Operation
|<9> Product Special Operation
|<0> Reboot
============================================================================
Ctrl+Z: Access EXTENDED ASSISTANT MENU
Ctrl+F: Format File System
Enter your choice(0-9):5
2. Follow the system instruction to complete the task.
If password recovery capability is enabled, first disable the capability from the CLI, and then
reboot the device to access the EXTENDED-BOOTWARE menu.
Password recovery capability is enabled. To perform this operation, first
disable the password recovery capability using the undo password-recovery
enable command in CLI.
If password recovery capability is disabled, enter Y at the prompt to complete the task.
Because the password recovery capability is disabled, this operation can
cause the configuration files to be deleted, and the system will start up
with factory defaults. Are you sure to continue?[Y/N]Y
Setting...Done.
261
|
|
|
|
|
|
|
|
|
|