Using The Extended-Bootware Menu (For All Mpus Except Lsu1Supb0(Jg496A)) - HP 10500 Series Configuration Manual

Table 29 Error messages
Error message
Invalid address.
Invalid length
Invalid value.
The value not fount.
Using the EXTENDED-BOOTWARE menu (for all
MPUs except LSU1SUPB0(JG496A))
To access the EXTENDED-BOOTWARE menu, press Ctrl+B within three seconds after the "Press Ctrl+B to
access EXTENDED-BOOTWARE MENU..." prompt message appears. If you fail to do this, the system
starts decompressing the Comware software.
RAM test successful.
Press Ctrl+T to start five-step full RAM test...
Press Ctrl+Y to start nine-step full RAM test...
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU...
Booting Normal Extended BootWare
The Extended BootWare is self-decompressing.........Done.
****************************************************************************
*
*
*
****************************************************************************
Compiled Date
CPU Type
CPU Clock Speed
Memory Type
Memory Size
Memory Speed
BootWare Size
Flash Size
BootWare Validating...
Press Ctrl+B to access EXTENDED-BOOTWARE MENU...
Password recovery capability is enabled.
Note: The current operating device is flash
Description
The start or end address is beyond the memory space or the end address is lower
than the start address.
The entered memory length is so great that the calculated end address is beyond
the memory space.
No value is provided at the prompt Enter the value to search for: before Enter is
pressed.
The specified value is not found in the specified memory space, or the length of the
specified value is not valid because it is not a multiple of 4 bytes.
BootWare, Version 1.03
: Jul 19 2014
: XLP208 Rev A2
: 1000MHz
: DDR3 SDRAM
: 8192MB
: 667MHz
: 1536KB
: 4MB
267
*
*
*