Skipping Console Login Authentication - HP 10500 Series Configuration Manual

===================<BOOTWARE OPERATION ETHERNET SUB-MENU>===================
|<1> Update Full BootWare
|<2> Update Extended BootWare
|<3> Update Basic BootWare
|<4> Modify Ethernet Parameter
|<0> Exit To Main Menu
============================================================================
Enter your choice(0-4):
Table 27 BOOTWARE OPERATION ETHERNET submenu options
Option
<1> Update Full BootWare
<2> Update Extended BootWare
<3> Update Basic BootWare
<4> Modify Ethernet Parameter
<0> Exit To Main Menu

Skipping console login authentication

IMPORTANT:
To perform this task, make sure password recovery capability is enabled. If the capability is disabled,
•
you cannot perform this task.
Perform this task only if the switch has one MPU. If the switch has two MPUs, you cannot skip console
•
login authentication.
If you cannot remember the console login password, enter 8 in the EXTENDED-BOOTWARE menu, and
then enter 1 or 0 in the EXTENDED-BOOTWARE menu. The switch will reboot and load the next-startup
configuration file with the console login password ignored.
Enter your choice(0-9): 8
Clear Image Password Success!
After the switch starts up, you can configure a new console login password and save the running
configuration so the new password takes effect (see
login password, the old password continues to take effect for the subsequent reboot.
Task
Upgrade the entire BootWare image.
Upgrade the extended segment.
Upgrade the basic segment.
Configure the FTP or TFTP file transfer settings.
Return to the BootWare Operation menu.
Figure 53). If you do not configure a new console
264
|
|
|
|
|