ISSUE 1.0
E1 Alarm Mode
Refer to following figure for LED pattern information. LED indications for the E1 are listed in
Table 2-25 E1 LED Indications on page
120 ms
LOS
green
AIS
green
OOF
green
RAI
green
TS16
green
Figure 2-76 LED Indication Pattern of Layer 1 on E1 Board
Alarm
LOS
LOS (Loss of Signal (Red Alarm))
No Signal (Analog Interface)
AIS
AIS (Alarm Indication Signal (Blue Alarm))
OOF
OOF (Out of Frame (Red Alarm))
RAI
RAI (Remote Alarm Indication (Yellow
Alarm))
TS16
TS16 (Receive Time Slot 16 all Alarm)
No alarm
System does LED control
The order of priority is set up to alarm in the order LOS → AIS → OOF → RAI → TS16.
Hardware Manual
2-59.
1 cycle 3.8 sec (120 ms x 32 = 3840 ms)
Table 2-25 E1 LED Indications
Details of the Alarm
The LED Indication Pattern
Following an alarm blink twice (green), a green LED lighting
up.
Following an alarm blink twice (green), a green LED flashes
on and off slowly twice
Following an alarm blink twice (green), a green LED flash on
and off 3 times simultaneously.
Following an alarm blink twice (green), a green LED goes
off.
An alarm blink repeat twice by 1 cycle.
SL2100
2-59