Figure 3-5 Entering Programming Mode Display 1 (12Txh/24Txh-A1); Figure 3-6 Entering Programming Mode Display 1 (12Txh/24Txh-B1); Figure 3-7 Entering Programming Mode Display 2 (12Txh/24Txh-A1); Figure 3-8 Entering Programming Mode Display 2 (12Txh/24Txh-B1) - NEC SL2100 Hardware Manual

SL2100
S 2 PROGRAMMING MODE
ECTION
2.1 Entering the Programming Mode
The installer/system administrator can enter to the system programming mode from the Display Type
Multiline Telephone. (A maximum of two users can enter mode at the same time)
In a newly installed system, use extension port 1.
1. Press Speaker key. (Do not lift the handset)
2. Dial # # .
* *
200

Figure 3-5 Entering Programming Mode Display 1 (12TXH/24TXH-A1)

11-10 WED 1:49PM
200
Menu Dir VM:00 CL:00

Figure 3-6 Entering Programming Mode Display 1 (12TXH/24TXH-B1)

3. Dial the system password, then press Hold key to enter the Program Mode.
Password@@@@@@@@

Figure 3-7 Entering Programming Mode Display 2 (12TXH/24TXH-A1)

Password@@@@@@@@

Figure 3-8 Entering Programming Mode Display 2 (12TXH/24TXH-B1)

For the details of programming, refer to the SL2100 Programming Manual. (separate issue)
3-4
TUE18 7:27PM
Password
Password
Program Mode
Program Mode
Base Service OP1 OP2
ISSUE 1.0
System Start Up