Figure 3-18 Inserting The Sd Card; Figure 3-19 Prg90-04 Display (12Txh/24Txh-A1); Figure 3-20 Prg90-04 Display (12Txh/24Txh-B1); Figure 3-21 Next Prg Display (12Txh/24Txh-A1) - NEC SL2100 Hardware Manual

ISSUE 1.0

2.4 Loading the Customer Data

The backed up customer data can be loaded to the system by SD Card.
For the details of the CPU board installation, refer to Installing the CPU board (IP7[ ]-CPU-C1).
1. Turn the power off, insert the Customer Data SD card into the SD Slot on CPU board.
SD slot (J12)
2. Turn the power on, enter the Program Mode then PRG90-04.
Program Mode
Base Service OP1 OP2
3. Dial 1 and press Hold key.
4. When the data loading is completed, the display changes to the next PRG.
9004-01
Loading Data
Loading System Data
5. Remove the SD card and exit from the Program Mode.
Hardware Manual

Figure 3-18 Inserting the SD card

Figure 3-19 PRG90-04 Display (12TXH/24TXH-A1)

Program Mode

Figure 3-20 PRG90-04 Display (12TXH/24TXH-B1)

Figure 3-21 Next PRG Display (12TXH/24TXH-A1)

Figure 3-22 Next PRG Display (12TXH/24TXH-B1)

CPU board
SD card with
Customer data
9004-01
Data Load
90-04-01
Data Load YES:1 1
,
9005- M tenanc
Slot Control
90-05- M'tenance
Slot Control
back Select
SL2100
|01
3-7