Figure 4-3 Removing The Cpu Board; Replacing The Lithium Battery - NEC SL2100 Hardware Manual

SL2100
NEC recommends that a backup of the customer data is performed before
powering off the system (either PCPro file or SD card backup) in order to
replace the backup battery.
• Risk of explosion if the battery is replaced by an incorrect type.
• Dispose of used batteries as instructed by the manufacturer of the battery.
• If Expansion Chassis are installed, turn the power on/off in the order of
Expansion 2 Chassis, Expansion 1 Chassis and then Main Chassis.

1.3 Replacing the Lithium Battery

Not all boards are hot swappable. Do not remove or install from the chassis
when powering up.
1. Power off the system.
2. After the system powers down, loosen two screws and pull out the CPU board.
4-2

Figure 4-3 Removing the CPU Board

CPU board
Screws
Maintenance
ISSUE 1.0