Figure 3-13 Inserting The Sd Card; Figure 3-14 Prg90-03 Display (12Txh/24Txh-A1); Figure 3-15 Prg90-03 Display (12Txh/24Txh-B1); Figure 3-16 Prg90-04 Display (12Txh/24Txh-A1) - NEC SL2100 Hardware Manual

SL2100
1. Turn the system power off, insert the blank SD Card (1 GB or larger) to the SD slot on the CPU
board.
SD slot (J12)
2. Turn the power on, enter the Program Mode then PRG90-03.
Program Mode
Base Service OP1 OP2
3. Dial 1 and press Hold key.
4. When the data backup to the SD Card is completed, the display will be changed to the next PRG.
9003-01
SavingSystemData
Saving System Data
5. Remove the SD Card and exit from the Programming Mode.
The saved data on SD Card cannot be edited by the PC.
3-6

Figure 3-13 Inserting the SD Card

Figure 3-14 PRG90-03 Display (12TXH/24TXH-A1)

Program Mode

Figure 3-15 PRG90-03 Display (12TXH/24TXH-B1)

Figure 3-16 PRG90-04 Display (12TXH/24TXH-A1)

Figure 3-17 PRG90-04 Display (12TXH/24TXH-B1)

CPU board
Blank SD Card
9003-01
Data Save
90-03-01
Data Save YES:1 1
,
9004- M tenanc
Load Data
'
90-04- M tenance
Load Data
back Select
ISSUE 1.0
|01
System Start Up