NEC SL2100 Hardware Manual page 16

SL2100
System knockout panels are only allowed to be cut using side cutters. Box cutter/knife is not allowed
to be used.
If liquid reaches the inside of the system or the main power source, turn off the power. Operating the
system in this state might cause a fire, an electrical shock, or a system failure.
Do not touch the internal parts of the main power source to disassemble or configure it. This action
may cause a fire, an electrical shock or a system failure.
NEC Corporation does not take any responsibility for disassembled or reconfigured equipment.
Do not put any container objects (such as a vase or a cup) on the main power source or any peripher-
al equipment. It might cause a fire, an electrical shock or a system failure.
Be sure to use cables designated by NEC or cables attached to the equipment. If cables are not des-
ignated particularly, choose cables with considering safety and transmission performance carefully.
Ask the dealer or your local agency if needed.
Do not tamper with, modify, forcefully bend, forcefully remove or twist an electrical cord or any wiring
to or from the system, the main power source or any peripheral equipment. It might cause a fire, an
electrical shock, or a system failure. If the wiring is damaged, contact the dealer.
Correctly insert all of the electrical plugs into the electrical outlets. Before inserting a plug into an elec-
dust
trical outlet, ensure that there is no dust on the plug's blades. If there is dust on a blade, it might
cause a fire.
Do not use power other than the power that was designated for the system when it was installed.
Do not attempt to repair or move the main power source without assistance from the dealer.
Do not put any metal or combustible objects into a vent of the system, the main power source, or any
peripheral equipment. Operating the system in this state might cause a fire, an electrical shock, or a
system failure. If this occurs, turn off the power and contact the dealer.
Be careful when using any peripheral equipment's Liquid Crystal Display (LCD). If the liquid leaks, it
can be harmful to the user and to the system.
Before connecting any non-NEC, customer-provided equipment, check with the supplier to ensure
?
that the equipment is compatible. If the supplier cannot confirm the compatibility, do not connect the
equipment. Connecting incompatible equipment might cause a fire or an electrical shock.
R-2
DANGER
ISSUE 1.0
PRODUCT LIABILITY