Control With Graphic Display - Siemens SIPROTEC 5 Operation Manual

Go to the menu item Switching mode.
²
Select Interlocked or Non-interlocked and confirm with Ok.
²
You can set this switchover after entering the confirmation ID.
²

Control with Graphic Display

8.8.5
Devices with a graphic display can depict a single-line diagram of the field in the control display, see
Figure 8-62. You can create the control display with the display editor of DIGSI 5. The display becomes active
directly after activation. You can reach the display at any time by pressing the yellow <Ctrl> key.
[scabzstb-280211-01.tif, 1, en_US]
Figure 8-62
Selecting a Switching Device
From this control display you can select the individual switching devices using the navigation keys. After the
position has been switched, the feedback is shown directly in the control display. A separate default display
(single line without control capability) is not present but can be created.
Initiating command
•
Select the switching device to be controlled using the navigation keys.
•
Then enter the new target position ON or OFF with the corresponding control key (green <I> for on, red
<O> for off). The switching device flashes in the target position.
•
Confirm the query with the softkey marked Ok in the display.
If the switching operation is permissible, it is executed, otherwise you receive a notification about the cause of
rejection.
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-7, Edition 06.2016
Control display
Operation in the Operating State
8.8 Control System on Site
169