Expanding 1St Device Row - Siemens SIPROTEC 5 Operation Manual

[dwauize1-040211-01.tif, 1, --_--]
Figure 2-2
(1) Distance frame
(2) Mounting bracket
(3)
Distance frame on base module rotated by 180

Expanding 1st Device Row

2.2.2
Preparation
NOTE
i i
Reordered modules are not contained in the original device configuration. Use DIGSI to perform the corre-
sponding extension in the Hardware and Protocols Editor.
Carry out the steps described in this chapter if you wish to expand an installed device later on with expan-
sion modules.
Shut down the device.
²
Detach all on-site operation panels from the distance frames.
²
Remove the mounting brackets.
²
NOTE
i
i
If the device is an expanded device, then detach the 2 mounting brackets. You must replace these
mounting brackets with 2 new mounting brackets that match the width of the device.
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-7, Edition 06.2016
Device Row
2.2 Surface-Mounting Devices with Integrated On-Site Operation Panel
o
Expanding Devices
25