Kenwood WD-K10 Series User Manual page 10

1 INTRODUCTION
1.7 System Configuration
System Type
This product is a DECT intercom system that combines and uses both base and sub units.
The system may be of a portable or non-portable type, depending on the type of base unit.
Note
The base and sub units have already been configured for your system when you receive the transceiver. For details
0
on system configuration and setup, please consult the authorized dealer or installer.
Portable Type
0
Stand-alone
One Portable Base WD-K10PBS is operated as a base unit.
Up to 10 sub units can be connected at Normal Audio Quality using the Portable Base WD-K10PBS (Transceiver Mode) or
the Transceiver WD-K10TR. Up to 5 sub units can be connected at High Audio Quality (including the base unit, maximum
11 units (or 6 units at High Audio Quality) can be used for simultaneous calls).
Note
To operate the Portable base as a sub unit, the mode on WD-K10PBS must be switched (
0
You can use the system setup to change the quality mode from Normal Audio Quality to High Audio Quality for clearer
0
and crispier calls. For details on the settings, please consult the authorized dealer or installer.
Blinking orange
Blinking green
WD-K10TR
WD-K10PBS
(Base Station Mode)
Contents
WD-K10PBS
(Transceiver
Mode)
on page 38).
9