Contents - Kenwood WD-K10 Series User Manual

1 INTRODUCTION
1.8 Part Names and Functions (Device Connection Method)
Power key
H
Press and hold to turn the power on/off. Press to check the remaining capacity in the battery. The battery charge LED
blinks.
Microphone
I
When making a call with the transceiver without using the clip microphone, speak into this microphone.
0
This key is disabled when a clip microphone or headset microphone adapter which is sold separately is connected.
Microphone/ Earphone jack
J
For connecting a clip microphone, earphone or headset microphone adapter which is sold separately. Do not connect
any device other than the compatible models.
Battery Charge LED
K
Indicates the charging status.
Light up : Charging in progress
Blinking : Charging in preparation, or charging error
Light goes off : Charging complete
[J]/[K] key
L
For adjusting the receiver volume level. The receiver volume changes with each press of the J/K key, from level 1 to
15. For details, refer to "Adjusting the Receiver Volume Level" (
Data setting connector
M
For registering the transceiver to the system or changing the settings.
0 Normally not used. Do not open the cover. And do not touch the connector.
Charge contact terminal
N
on page 39).

Contents

14