Kenwood WD-K10 Series User Manual page 39

2 PREPARATION
2.3 Registering the Device
Starting WD-K10PBS in Transceiver Mode
WD-K10PBS can be used as a base unit or sub unit.
To use as a sub unit, perform the following operations and start in Transceiver Mode.
Precautions
0 The mode in WD-K10PBS has been configured to your system in advance. Unless it is necessary, do not change the
startup mode. For details on the settings, please consult the authorized dealer or installer.
1
If the unit is turned on, turn off the power by pressing and holding the
goes off.
2
While pressing the
For turning on the power, refer to
The unit enters into Transceiver Mode. Voice announcement for the activation of Transceiver Mode is being played
and the Status LED blinks in green.
The following table shows the Status LED indication and voice announcement during the activation of Transceiver
Mode and Base Station Mode.
Startup Mode
Base Station Mode
Transceiver Mode
Note
Once the unit is start in Transceiver Mode, it will start in Transceiver Mode the next time simply by turning on
0
the power.
Performing the same operations when in Transceiver Mode (sub unit) changes the unit to Base Station Mode
0
(base unit).
The voice announcement may not be played depending on the transceiver settings. (
0
[PF 1] key, turn on the power by pressing and holding the
Turning on the Power on page
Group LED
Status LED
LED Indication
Blinking orange
Blinking green
[Power] key until the Status LED
[Power]
33.
[PF 1] key
[Power] key
Voice Announcement during Mode Activation
Base Station
Transceiver
Contents
key.
on page 47)
38