Table of Contents
Advertisement
2 PREPARATION
2.2 Turning On/Off the Device Power
Turning On/Off the Power of WD-K10PBS / WD-K10TR
Turning on the Power
1
Hold down the
[Power]
up and then light off.
0
Base Station Mode
When the unit is linked to the system, the Status LED blinks in orange. Group LEDs of the connected group light up for a few
seconds and then blink. Voice announcement for the connected group is being played and the unit enters Group Call Mode.
0
Transceiver Mode
When the unit is linked to the system, the Status LED blinks in green. Group LEDs of the connected group light up for a few
seconds and then blink. Voice announcement for the connected group is being played and the unit enters Group Call Mode.
When the unit is unable to link to the system, the Status LED lights up in red. Move to a location where linking is possible.
Turning off the Power
1
Hold down the
[Power]
Check that the LED lights off and is not blinking.
key. Release after the Status LED (red), Group LEDs, and Battery Charge LED light
Group LED
Status LED
Battery Charge LED
key until the Status LED lights off.
[Power] key
[Power] key
Contents
33
Hide quick links:
Advertisement
Table of Contents
