Panasonic LB-DH7 Series Operator's Manual page 81

Others
Email
Code
notification
W1112
s
W1120
s
W2000
±
W2001
W2003
±
W2010
±
W2011
±
W2020
±
W2030
s
W2040
s
W2050
s
W2051
W2120
s
W2130
s
W2140
s
Errors and warnings
SNMP trap
notification
The command for a software update was set while software was being updated.
s
Self-diagnostics is re-specified during self-diagnostics.
s
)Wait for the self-diagnostics to complete.
Performance of the changer mechanism operation in the changer
unit has deteriorated.
±
)The maintenance of the changer mechanism or peripheral circuit
is recommended.
Performance of the changer unit's circuit board has deteriorated.
±
)The maintenance of the circuit board or peripheral circuit is
recommended.
The detected number of times of magazine loading is nearly equal
to the prescribed value.
)Check the number of times of magazine loading by Web
±
interface. We recommend copying the contents of the magazine
to another magazine. (
to a spare magazine case by performing "Replace Magazine".
( 52)
The verify function has detected that the writing quality is not
suitable for storage.
±
)Check the status of the magazine through the Web interface or
the S.M.A.R.T. information in the log. We recommend copying the
contents of the magazine to another magazine. (
In spite of a failure, the magazine move operation continued
normally after a retry.
±
)If a warning message is displayed again, draw the magazine
drawer including the magazine in question to check if all
magazines have been set correctly.
An incompatible magazine has been set.
s
)Take out the magazine.
The specified processing cannot be performed because the
s
magazine drawer is open.
)Close the magazine drawer and retry the processing.
Failed to communicate with the drive system.
s
)Replacing the drive system is recommended.
The specified processing cannot be performed because an
application inhibits the disc from being taken out of the drive system.
s
)Retry the processing after the application allows the disc to be
taken out of the drive system.
The specified processing cannot be performed because an
application inhibits the magazine drawer from being unlocked.
s
)Retry the processing after the application allows the magazine
drawer to be unlocked.
The changer unit is operating.
s
)Check the changer status by Web interface and retry processing
after the status changes to "Ready".
81
Action to be taken
33) It is also possible to move the discs
38, 62)