Panasonic LB-DH7 Series Operator's Manual page 82

Others
Email
Code
notification
W2150
s
W3000
±
W3010
±
W3011
±
W3020
±
W3030
±
W3040
±
Errors and warnings
SNMP trap
notification
The specified processing cannot be performed because of the magazine
s eject mode set for taking out a disc specified by an application.
)Turn off the magazine eject mode on the application, and try again.
Detected that the life of the drive system is nearly at its end.
±
)Replacing the drive system or peripheral circuit is recommended.
The redundancy of writing has decreased owing to a drive system
fault or a media defect during RAID writing.
±
)Check the log records to determine if there is a drive system or
magazine defect, and if yes, take proper action in accordance
with the error or warning code corresponding to the defect.
When reading RAID, the read redundancy is low due to a failure of
the drive system or media.
±
)Check the log records to determine if there is a drive system or
magazine defect, and if yes, take proper action in accordance
with the error or warning code corresponding to the defect.
A fault has been detected in several of the drives of the drive
system.
The redundancy at RAID writing or RAID reading decreases. To
±
recover the redundancy, repair the drives.
)For information on the conditions that cause the warning, refer to
"RAID functions" (
One or more drives or discs in the drive system have failed to
startup. Redundancy during RAID writing or RAID reading is
±
reduced. Repairs might be required for recovery.
)For information on the conditions that cause the warning, refer to
"RAID functions" (
Writing to the magazine is not possible because the magazine
± management information area has run out.
)Take a copy to another magazine.
82
Action to be taken
54).
54).