Module Installation; Specifications Of Rework - Huawei MU509 Series Hardware Manual

HUAWEI MU509 Series HSDPA LGA Module
Hardware Guide

6.9.5 Module Installation

Install the module precisely on the module and ensure the right installation direction of
the module and the reliability of the electrical connection with the PCB. It is
recommended that the module be preheated in order to ensure that the temperature
of all parts to be soldered is uniform during the reflow process. The solder quickly
reflows upon heating so the parts are soldered reliably. The solder joints undergo
proper reflow duration at a preset temperature to form a favorable Intermetallic
Compound (IMC).

6.9.6 Specifications of Rework

Temperature parameter of rework: for either the removing or welding of the module,
the heating rate during the rework must be equal to or smaller than 3°C/s, and the
peak temperature between 240°C–250°C. The following parameters are
recommended during the rework.
Figure 6-8 Temperature graph of rework
Issue 09 (2014-03-06)
It is recommended that a fixture and a mini-stencil be made to apply the solder paste in the
rework.
It is recommended that a special clamp be used to pick the module when the module is

installed on the pad after applied with some solder.
A special rework device must be used for the rework.

Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Process Design
84