Siemens SINAMICS G130 Engineering Manual page 156

General Engineering Information for SINAMICS
Engineering Information
View of the Advanced Operator Panel 30
The AOP30 communicates with the SINAMICS / CU320 Control Unit via a serial interface (RS232) with PPI protocol.
The interface is a point-to-point connection. During communication, the AOP30 is the master and the connected unit
is the slave.
The AOP30 supports configuration of multiple motors on one Control Unit. Both the messages and parameters of all
connected units are accessible at all times.
The AOP30 is an operator panel with a graphic display and a touch-sensitive keypad. The device can be installed in
a cabinet door (thickness: between 2 mm and 4 mm).
Dimensions of the Advanced Operator Panel 30
SINAMICS Engineering Manual – May 2008
156/396
© Siemens AG
Key assignment:
Functions
Menu
Operating / Parameterizing lock
Numerical keypad
Local / Remote switchover
ON/OFF
Clockwise / Counter-clockwise switchover
Jog
Setpoint increase / decrease
Features
Display with green
backlighting,
resolution: 240 x 64 pixels
26-key touch-sensitive
keypad
Connection for a 24 V DC
power supply
RS232 interface
Time and date memory
powered by internal battery
backup
4 LEDs indicate the
operating status of the drive
unit:
– RUN green
– ALARM amber
– FAULT red
– LOCAL/REMOTE green