Operating Modes, Overview And Selection - ABB HART Industrial IT enabled TZIDC Operating Instructions Manual

3.4.2 Operating modes, overview and selection

Procedure for mode selection from the operating level:
• Press and hold
• Additionally briefly press
The selected mode is indicated.
• Release
MODE
• The position is indicated as a percentage or rotation angle.
Overview
Mode
1.0
Control*
with adaptation
(of control parameters)
1.1
Control
without adaptation
(of control parameters)
1.2
Manual adjustment** within
the operating range.
Press or
1.3
Manual adjustment** within
the sensor range.
Press or
*) Self-optimization during "adaptive" control is subject to various influences during
operation that may lead to mismatches in the long run. Therefore, it is recom-
mended to use this operating mode for some hours only and then switch the posi-
tioner to mode 1.1 "Control without adaptation".
**) Positioning not active
***) For quick motion: Press
41/18-79 EN
.
MODE
as often as required.
.
Mode display
conf
conf
conf
to adjust ***
conf
to adjust ***
and
Electro-pneumatic positioner TZIDC
Position display
° C
%
mA
conf
° C
%
mA
conf
° C
%
mA
conf
°
C
%
mA
conf
together.
°
C
%
mA
° C
%
mA
°
C
%
mA
°
C
%
mA
27