Getting Started; Turn On Web Server - Siemens Synco OZW772 Series Commissioning Instructions

Turn on Web Server

Note
Siemens
Building Technologies
2.2

Getting started

2.2.1 Turn on Web Server
Connect the Web Server to the power supply and connect it to the PC:
1. Connect power supply to turn on power on Web Server. The Web Server is
operational, when the green
2. Check additional displays:
· LED
Green light if the KNX bus power supply is available. Check KNX bus
wiring and setting for bus power supply on the KNX devices if no bus
power supply is available.
· LED
Dark if no fault pending. You can troubleshoot pending faults later (see
Section 4.3).
3. Plug the supplied USB cable into the Web Server and the PC and start up
the PC. The PC recognizes the Web Server as a USB device.
Otherwise, the RNDIS is still not installed.
4. The RNDIS driver is installed automatically if the PC is connected to the
Internet and no RNDIS driver is installed as long as the Microsoft online
update is enabled. Follow the instructions for the installation program.
You can also manually setup the RNDIS driver (see Section 11.3.3).
Web server OZW772... V6.0
Commissioning
LED is lit.
15 / 176
CE1C5701en
2015-10-12