Siemens Sinumerik 840D Series Function Manual page 131

08.99
10.03
5285
OUTPUT_FIL_1_DAMP [n]
Damping of control output filter 1
Unit: Default:
- 1.0
5288
OUTPUT_FIL_1_SUP_FREQ [n]
Blocking frequency of control output filter 1
Unit: Default:
Hz 3500.0
5289
OUTPUT_FIL_1_BW [n]
Bandwidth of control output filter 1
Unit: Default:
Hz 500.0
5290
OUTPUT_FIL_1_BW_NUM [n]
Numerator bandwidth for control output filter 1
Unit: Default:
Hz 0.0
 Siemens AG, 2003. All rights reserved
SINUMERIK 840D/SIMODRIVE 611 digital, HLA Module (FBHLA) - 10.03 Edition
0...7 index of the parameter set
Minimum: Maximum:
0.05 1.0
Enter damping for control output filter 1 (PT2 low-pass).
0...7 index of the parameter set
Minimum: Maximum:
1.0 7999.0
Enter blocking frequency for control output filter 1 (bandstop)
0...7 index of the parameter set
Minimum: Maximum:
5.0 7999.0
Enter -3dB bandwidth for control output filter 1 (bandstop).
0...7 index of the parameter set
Minimum: Maximum:
0.0 7999.0
Enter the numerator bandwidth for control output filter 1 (damped bandstop).
Entering a value of 0 initializes the filter as an unattenuated bandstop filter. The
value set in MD 5290 must not exceed twice the value set in MD 5289.
4 Firmware Drive Functions
4.5 Manipulated voltage output
Cross reference: -
Related to:
Protection level:
HLA
3/3
Data type: Active:
FLOAT Immediately
Cross reference: -
Related to:
Protection level:
HLA
3/3
Data type: Active:
FLOAT Immediately
Cross reference: -
Related to:
Protection level:
HLA
3/3
Data type: Active:
FLOAT Immediately
Cross reference: -
Related to:
Protection level:
HLA
3/3
Data type: Active:
FLOAT Immediately
4-131