ABB i-bus EIB Product Manual page 4

®
ABB i-bus EIB / KNX
1 General
© 2004 ABB STOTZ-KONTAKT GmbH
General
The Switch/Dim Actuator Module SD/M 2.6.1, the Light Controller Module
LR/M 1.6.1 and the Universal Dim Actuator Module UD/M 2.230.1 are
snapped into a module slot of the Room Controller Basis Device RC/A 8.1.
They are used to control dimmable lighting.
The Room Controller Basis Device establishes the connection to the ABB i-
®
bus EIB / KNX installation bus.
The SD/M 2.6.1 dims electronic ballasts with a 1...10 V interface. It has two
independent outputs for dimming and switching two groups of luminaires.
The LR/M 1.6.1 dims one group of luminaires with electronic ballasts with a
1...10 V interface. There is an additional input for connecting a light sensor
LF/U 1.1 in order to implement constant lighting control.
The UD/M 1.300.1 dims a group of luminaires with max. 300 W (VA) output
capacity. It is designed for operation with different types of luminaires (load
types):
•
Incandescent lamps (resistive load)
•
230 V halogen lamps (resistive load)
•
Low voltage halogen lamps on wound (inductive load) or electronic
(capacitive load) transformers.
The devices are automatically connected to the incoming supply when they
are snapped into the Room Controller Basis Device. On the output side, the
devices have screw terminals with plug-in connection.
The comprehensive functionality is defined by programming the Room
Controller Basis Device with the EIB Tool Software (ETS). It is very similar
for all three devices.
4