Parameter Window: "Control - ABB i-bus EIB Product Manual

®
ABB i-bus EIB / KNX
4.6.3 Parameter window:
"Control"
© 2004 ABB STOTZ-KONTAKT GmbH
Project design and programming
Parameter: "Light controller operates as 'master' of other dimmer
actuators"
It is set here whether the light controller controls further dimming actuators
("slaves") via a 1-byte brightness value.
Parameter: "Changing brightness during lighting control"
This parameter defines how quickly the lighting changes if the lighting
control is active. For reasons of comfort, the change in the brightness level
should not be noticeable.
Normally, it is possible to choose between "fast", "medium" and "slow". In
master mode, only the options "medium" and "slow" are possible in order to
limit the bus load.
Parameter: "Allow switching on/off during lighting control"
It can be set here whether the lighting may be switched on and off while the
lighting control function is active ("switching on and off"), may not be
switched on again ("switch off only") or remains at least at the lower dimming
limit ("no").
Parameter: "Upper dimming boundary during active control"
The largest brightness value which the dimmer can trigger during lighting
control is set here.
Parameter: "Lower dimming boundary during lighting control"
The smallest brightness value which the dimmer can trigger during lighting
control is set here.
Parameter: "State of light control after mains voltage recovery"
It can be set in this parameter whether the control is "active" or "inactive"
once the supply voltage of the device has recovered. In the setting "inactive",
the brightness value follows the setting in the "General" parameter window.
...
...
29