Parameter Window: "Function - ABB i-bus EIB Product Manual

®
ABB i-bus EIB / KNX
4.2.2 Parameter window:
"Function"
© 2004 ABB STOTZ-KONTAKT GmbH
Project design and programming
Additional functions of the output can be enabled in this parameter window.
Parameter: "Enable function 'preset'"
The "Presets" function can be enabled via this parameter. The function is
used for retrieving or storing brightness values via 1-bit objects.
See under the "Presets" parameter window for further information.
Parameter: "Select extra function"
An additional parameter window can be enabled via this parameter, in which
one of several additional functions can be set.
The possible additional functions are dependent on the type of the module:
Control lighting
Slave mode in lighting control
Staircase lighting function
Lightscene (8-bit)
Parameter: "Enable function 'blocking'"
This parameter is only visible if an additional function has not been selected.
The "Disable" object is enabled here. The function of the output can be
disabled via this object so that it cannot be modified via the EIB.
Parameter: "Enable characteristic adjustment"
If "yes" is entered in this parameter, the parameter window "Characteristic
adjustment" is enabled. The dimming characteristic curve (lighting
dependent on the brightness value) can be modified via this parameter.
Further information about this function can be obtained in section 3.5.
Parameter: "Enable fct. 'priority / forced operation'"
The object "Priority / forced operation" can be enabled via this parameter.
Parameter: "Brightness while priority is on (forced operation = active,
ON)"
This parameter is visible if the additional function "Enable fct. 'priority /
forced operation'" has been activated. The brightness value is set here
which is adopted when the object "Priority / forced operation" has the value
"3" ( = "ON, activate forced operation").
...
SD/M 2.6.1 LR/M 1.6.1
X
X X
X X
X X
UD/M 1.300.1
X
X
X
21