®
ABB i-bus
EIB / KNX
2
Device technology
2.1
SD/M 2.6.1
Switch/Dim Actuator
Module, 2-fold, 6 A
2.1.1
Technical data
Power supply / incoming supply
Outputs
Connections
Ambient temperature range
Design
CE norm
© 2004 ABB STOTZ-KONTAKT GmbH
Device technology
The Switch/Dim Actuator Module is operated in a module slot of the Room
Controller Basis Device. It dims electronic ballasts with a 1...10 V interface.
The device has two independent outputs for dimming two groups of
luminaires. One relay contact per channel is used to switch the lighting
circuit on/off.
The device operates passively i.e. its 1...10 V output behaves like a
controlled resistor. The connected electronic ballast supplies the control
voltage.
Both the incoming supply and the internal voltage are supplied via the Room
Controller Basis Device. Contact is automatically established when the
modules are snapped in place.
– Operating voltage
– Incoming supply
– 2 load circuits
– 2 control outputs
– Load circuits
– Control outputs
– Wire ranges
– Storage
– Transport
– Type of installation
– Housing, colour
– Housing dimensions (WxHxD)
– Weight
– in accordance with the EMC guideline and
the low voltage guideline
made available via the Room Controller Basis
Device, contact made via contact system on
base of module
0 ... 264 V, contact established via contact
surfaces at the front
Relay outputs
Switching current: 10 A / AC1
Continuous current: 6 A
Max. capacity: 35 µF
1...10 V DC (passive)
Control current: < 30 mA
2 x 3-pole, plug-in screw terminals
2 x 2-pole, plug-in screw terminals
2
0.2...2.5 mm
finely stranded
2
0.2...4.0 mm
single-core
-25 °C ... 55 °C
-25 °C ... 70 °C
For snapping into the
Room Controller Basis Device
Plastic housing, anthracite, halogen-free
49 x 42 x 93 mm
0.1 kg
5