Chapter 2 Configuring and Upgrading the System
ft server utility
Select ftServer - CPU Module - CPU Module (to be removed) - CPU Module Start/Stop – Stop.
Repeat the steps above for the PCI module and confirm that the status of the CPU/IO module and
the IO module (PCI module) are "Removed".
2. Remove the front bezel
3. Disconnect the power cord of a module to be removed.
The stopper will go down when you disconnect the cable.
When removing CPU/IO module 0, select Stop for CPU module (ID:0) and PCI module
Tips
(ID:10)
Check whether the stopper goes down after disconnecting the power cord. If you
Note
disconnect the cable and the stopper does not go down, you cannot pull out the CPU/IO
module in the next step.
Express5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)
5. Installing and Replacing Optional Devices
Stopper
123