Removing 2.5-Inch Hard Disk Drive - NEC Express5800 Series Maintenance Manual

Chapter 2 Configuring and Upgrading the System
5.3.2

Removing 2.5-inch Hard Disk Drive

Follow the procedure below to remove the hard disk drive.
Below is procedure with the system started.
1. Clear the dual disk configuration by referring to Chapter 2 (1.6 How to Clear the Duplication of the Hard
Disk Drive).
2. Remove the front bezel.
3. Push the lever of the hard disk to unlock the drive,
and pull the handle toward you.
4. Hold the handle and hard disk drive to pull them off.
118

See Chapter 2 ("5.1.3 Installing, Removing and Replacing Devices") and Chapter
Important
1 (1.8 Anti-Static Measures )in Safety Precautions and Regulatory Noticesbefore
starting installing or removing options.

Make sure that the dual disk configuration is cleared by referring to Chapter 2
(1.6 How to Clear the Duplication of the Hard Disk Drive) before removing the
hard disk drives.

If the RAID device of which you will remove the hard disk drives is set to mount
automatically, clear the setting by editing /etc/fstab in advance.

If you remove the hard disk drive with the system turned off, clear the setting to
mount the RAID device automatically by editing /etc/fstab on OS in advance. If
the RAID device is deleted without above, the system may not start up normally.
Express5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)
5. Installing and Replacing Optional Devices