NEC Express5800 Series Maintenance Manual page 97

Chapter 2 Configuring and Upgrading the System
[List Internal Disks]
Slot Name [Use]
===============================================================================
1 104001(sdq) [0] HGST/HUC156030CSS200/#0TGR84RP
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 114001(sdr) [0] HGST/HUC156030CSS200/#0TGR63VP
10 -
11 -
12 -
13 -
14 -
15 -
16 -
5. Wait for about 5 minutes until the recovery process (resynchronization) starts automatically.
6. Execute "1 List RAID Arrays" of the ftdiskadm command, and check the recovery (DUPLEX).
[List RAID Arrays]
Name Partition
===============================================================================
< Mirroring Array (RAID1)
md123 /var/crash
md124 /boot/efi
md125 swap
md126 /boot
md127 /
The following appears during the recovery process. Check this again after a while.
[List RAID Arrays]
Name Partition
===============================================================================
< Mirroring Array (RAID1)
md123 /var/crash
md124 /boot/efi
md125 swap
md126 /boot
md127 /
Information (Vendor/Model/Serial)
Tips If the hard disk drive is not recovered automatically, execute "4 Repair Mirroring Arrays
(RAID1)" of the ftdiskadm command, and specify the slot number of the replaced hard disk
drive.
Status
>
DUPLEX
DUPLEX
DUPLEX
DUPLEX
DUPLEX
Status
>
RECOVERY(73.2%)
RESYNC
RESYNC
RESYNC
RESYNC
Express5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)
Member
(1)104001-part2 (9)114001-part2
(1)104001-part5 (9)114001-part5
(1)104001-part3 (9)114001-part3
(1)104001-part4 (9)114001-part4
(1)104001-part1 (9)114001-part1
Member
(1)104001-part2 R (9)114001-part2
(1)104001-part5 R (9)114001-part5
(1)104001-part3 R (9)114001-part3
(1)104001-part4 R (9)114001-part4
(1)104001-part1 R (9)114001-part1
1. Hard Disk Drive Duplexing
Path
h1c0t0l0
h2c0t0l0
97